Honda Element homeowners seeking to create a strong automobile stereo system have many options. You can improve your audio system to supply a better sound or switch to a more highly effective stereo deck. The surest option to deliver a cleaner, extra powerful sound in your Element is so as to add an amplifier. You may have an amplifier installed by a automotive audio skilled, or you can install an amp yourself for a fraction of the cost.
Honda Element Audio Amplifier Installation Instructions
1. Disconnect the negative battery cable from the Element’s battery. The negative cable is black and connects the battery with the body or chassis of the vehicle. Use a Phillips head screwdriver to loosen the cable’s clamp. Take away the clamp from the negative lead submit and rest it away from the battery.
2. Connect the amplifier ring terminal (from the amplifier wiring package) to the positive lead of the Element’s battery. Take away the fuse from the amplifier ring terminal and route the cable into the cabin of the Honda. Drill a gap in the firewall to the inside of the vehicle. Place a rubber grommet within the new opening to protect the ability cable.
3. Route the power cable to the rear of the Honda Element. Use a trim panel instrument to remove the panels within the doorways that secure the carpet to the floor. Run the wiring to the rear of the Element beneath the carpeting.
4. Take away the stereo. Use a trim panel device or flat screwdriver to pry the trim panel surrounding the stereo away from the dash. Work the flat instrument from the bottom across the perimeter of the panel until it’s completely free from the dashboard.
5. Take away the four screws on the corners of the stereo mounting bracket with a Phillips head screwdriver. Pull the stereo from its dock till the wire connections within the rear are reachable by hand.
6. Pull the wire groups from the stereo by the plastic wiring binders, not the wires themselves. Join the groups to a wiring harness adapter. The adapter will probably be clearly marked to show the place the connections ought to be made (both abbreviations or shade code). Join the wiring harness to the stereo.
7. Join the flip-on lead and sign cable (included within the amplifier wiring kit) to the wiring harness adapter and route the cables to the rear of the Honda. Guantee that the signal cable is routed on the alternative side of the Element as the facility supply to keep away from interference.
8. Connect the flip-on lead, the sign cable and the power provide to the amplifier. Connect speaker wire from the amplifier to the audio system you want amplified. Use the identical route established by the rear speakers’ wiring.
9. Join the grounding wire (amp wiring equipment) from the amplifier to a connection point on the Honda Element’s frame. Any bolt or screw will suffice.
10. Substitute the stereo within the Element’s stereo dock. Change the four screws into the stereo mounting bracket with a Phillips head screwdriver. Snap the trim panel on by hand around the stereo.
11. Substitute the negative battery cable onto the negative lead of the battery. Place the cable’s clamp across the negative lead post. Tighten the clamp with a Phillips head screwdriver. Place the fuse into the fuse holder on the amplifier ring terminal (related to the positive lead).
